Simrig Build Log — First Rig
First proper simrig. No aluminium profile kit, no second-hand seat — mostly scrap from the shed and a few bits I had to actually buy. This is the build log: what I picked, why, and where it went wrong.
Goals
- Direct drive wheel, no fancy pedal set
- Room for a standing desk next to it
- Total under €600 including the wheelbase
- Bolt-together, no welding
Parts list
- Wheel: 320mm round wheel with a quick-release hub
- Base: used direct drive wheelbase, bought second hand
- Pedals: DIY load cell pedals, 3D printed, strain gauge + HX711
- Frame: 40x40 aluminium profile, four lengths, corner brackets
- Seat: salvaged office chair seat on a plywood plate
- Deck: 18mm birch plywood, cut to fit the spare room
- Misc: M8 bolts, washers, cable trunking, a lot of zip ties
Assembly notes
The frame went together in an afternoon. Everything is bolted, so it comes apart in about ten minutes when I need the space back.
Lesson learned: measure the room with the pedals in your hands before
cutting the deck. I cut it 60mm short and had to add a spacer plate.
Wheelbase setup
wheelbase mode: native
rotation: 900 degrees
ffb: 100% overall, 65% road, 40% kerb
centre spring: off
Still tuning the force feedback curve. The default profile feels heavy mid-corner.
Current status
- Frame: done
- Pedals: working, need a better load cell mount
- Wheel: mounted, cable management outstanding
- Seat: mounted, slightly too far back
Next steps
- Cable chain along the upright
- Proper pedal plate with angle adjustment
- Dash display off an old phone